Tyan Thunder LE-T S2518 Motherboard

TYAN Updated: 2009-01-29 RSS
Tyan Thunder LE-T S2518 Motherboard

The Thunder LE-T was specifically designed for the Internet infrastructure. It supports two CPUs; either the Pentium III processor, or the Pentium III processor DP. With its high-performance ServerWorks chipset, 64-bit PCI bus, and integrated network, storage and video controllers, the Thunder LE-T provides superior performance and a wealth of integrated features. The Thunder LE-T's most intriguing feature is its form factor. Utilizing angled memory sockets and a highly integrated design, the Thunder LE-T is the perfect choice for today's 1U/2U servers.

* Processor
- Dual PGA370 ZIF sockets
- Supports up to two Intel Pentium III Processors or Pentium III Processors with 512kB Cache
- Onboard VRM (VRM 8.5 spec) supports 2 CPUs
- Front-Side Bus support for 100MHz and 133MHz

* Chipset
- ServerWorks ServerSet III LE3 chipset
- Integrated I/O APIC; OSB4 south bridge
- SMsC FDC37B787 Super I/O ASIC

* System Memory
- Four 25° angled 3.3v 168-pin DIMM sockets
- Angled sockets enable rackmount installation
- Supports up to 4GB Registered PC133 SDRAM
- Supports ECC (72-bit) memory modules

* Expansion Slots
- One 64-bit 66MHz (3.3-volt) PCI slot and one 64-bit 66MHz (5-volt) PCI slot.
- 3.3-volt slot supports Adaptec 2000S Zero-channel RAID controller
- Total of two usable slots (one if installed in 1U)
- PCI riser card required when installed in 1U/2U

* Integrated I/O
- One floppy connector supports up to two drives; microfloppy support via optional cable
- Two 9-pin 16550-based serial ports (one via optional cable); one 25-pin SPP/ECP/EPP parallel port via optional cable
- Four USB ports (two via optional cable)
- PS/2 keyboard and mouse ports

* Integrated PCI IDE
- Dual-channel master mode
- Up to four Enhance IDE devices
- Support for DMA33 IDE and ATAPI-compliant devices

* Integrated LAN Controllers
- Dual Intel 82559 LAN controllers
- 10/100Mbps max. data transfer rate per controller

* Integrated Video
- ATI RAGE XL graphics controller
- 4MB frame buffer (SDRAM)
- Standard 15-pin analog VGA port

* Integrated IDE RAID (optional)
- Promise FastTrak100 IDE RAID controller
- Dual-channel master mode
- Support up to four Enhanced IDE devices
- Support for UDMA 100/66/33 IDE drives
- Supports IDE RAID levels 0, 1 and 0+1

* Integrated SCSI (optional)
- Adaptec AIC-7899W controller
- Dual-channel Ultra160 SCSI support
- 160MB/sec maximum data throughput per channel; supports up to 15 LVD SCSI devices per channel

* Hardware Monitoring
- Winbond W83782D hardware monitoring ASIC; CPU temperature, voltage, and fan monitoring

* BIOS
- AMI BIOS on 4Mb Flash ROM
- Auto-configuration of IDE hard drive types
- Multiple boot options
- DMI 2.0 compliant

* Form Factor
- ATX footprint (12" x 9.6", 304.8mm x 243.84mm)
- One 20-pin ATX power connector
- One serial port and one VGA port
- Stacked USB (two) ports
- Side-by-side LAN (two) ports
- Stacked keyboard and mouse ports