Tyan Triumph i7320 S6621 Network Security Board

TYAN Updated: 2009-01-31 RSS

TYAN Triumph i7320 provides you the possibility to have max 4 GbE ports over Fiber connectors. The transmission length is at least 500M. Embedded with Cavium Nitrox CN1120, Triumph i7320 can process high-level IPsec and IKE, IPv6, SSL and Wireless LAN security protocol macro commands. This reduces the host I/O traffic and the load on the system processor. TYAN Triumph i7320 is ideal for distance and security oriented customers.

Processor
- Two 604-pin sockets support Intel® Xeon® processors of the same type listed below: 800 FSB w/ 1M L2 (Nocona), up to 3.6GHz; 800 FSB w/ 2M L2 (Irwindale), up to 3.6GHz
- Separated 4-phase VRD for each CPU

Chipset
- Intel E7320 Memory Controller Hub(MCH)
- Intel 82801EB I/O Controller Hub (ICH5)
- Two Intel 6700PHX PCI/PCI-X Controller Hub

Memory
- Four 240-pin DDR2 sockets support up to 8 GB
- Dual ch. memory bus (must populate in pairs)
- Registered DDR2 400 Compliant ECC DIMM
- Supports 256MB, 512MB, 1GB, 2GB DIMM
- Supports standard SEC-DED with 72-bit ECC DIMM or supports Intel x4 Single Device Data Correction (x4 SDDC)

Expansion Slots
- One 64-bit 133MHz PCI-X slot (3.3V)
- Supports up to three devices through riser card

Networking Security
- Onboard Cavium CN-1120-X Security Macro Processor supports IPsec/SSL (optional)

System Management
- Total three 3-pin fan headers with control and tachometer monitoring
- Monitors voltage for CPU, Mem. & Power Supply
- Monitoring temperature for CPU & environment
- Pin header for Fault LED, Power LED & HDD activity LED
- One pin header for Chassis Intrusion detection
- Supports Serial Console Redirect
- Private memory chip for security information
- Supports Watch Dog Timer

Integrated LAN Controllers
- Four Intel 82546EB dual port Gigabit Controllers
- Configurable with total 8 Gigabit LAN ports, Max. 4 of 8 ports could be over Fiber connectors (opt.)

Integrated Graphics
- Onboard ATI RAGE™ XL PCI graphics controller with 8MB memory

Integrated I/O
- One 50-pin Compact Flash Type II connector
- One 44-pin IDE connector; two SATA connectors
- One pin header for USB ports (supports two USB 2.0 devices)
- One serial port, one parallel port, one VGA port
- One pin header for PS/2 mouse and keyboard
- One pin header for SMBUS connection
- One pin header for Switch/ LED connection
- One pin header for Fiber LAN LED display

Back Panel I/O Ports
- One serial port w/ D-Sub connector
- Two USB 2.0 ports w/ dual-stack USB connector
- Eight RJ45 connectors with Transformer and LED
- Four of eight LAN ports could be configured to Optical SPF connectors (optional)

BIOS
- AWARD BIOS on 4Mbit Flash ROM
- Supports ACPI 2.0
- Supports boot from USB device
- Power-on mode control for AC power loss recovery

Form Factor
- EEB 3.51 form factor (12" x 13"; 305x330mm)