Tyan Triumph i7520 S6623 Network Security Board

TYAN Updated: 2009-01-29 RSS
Tyan Triumph i7520 S6623 Network Security Board

The TYAN Triumph i7520 supports two dual-core Intel® Xeon® processors and up to 8GB DDR2 memory. It uses Intel LAN controller to provide outstanding compatibility and performance. Designed for security applications, Triumph i7520 offers the possibility having maximum of 4 GbE ports over Fiber connectors, LAN-bypass option, and SO-DIMM slot which supports Tyan SAS Taro card or Cavium Security Macro Processor card.

- Two 604-pin sockets support Intel® Xeon® processors of the same type listed below:
-- Xeon® Dual Core (Paxville, 2MB L2); 2x
-- Xeon® (Nocona, 1M L2), up to 3.6GHz
-- Xeon® (Irwindale, 2M L2), up to 3.6GHz
-- Xeon® LV (Low Voltage) CPU, up to 2.8GHz
- Separated 4-phase VRD for each CPU

- Intel E7520 Memory Controller Hub (MCH)
- Intel 82801EB I/O Controller Hub (ICH5)
- Intel 6700PHX PCI/PCI-X Controller Hub

- Four 240-pin DDR2 sockets support up to 8 GB
- Dual ch. memory bus (must populate in pairs)
- Registered DDR2 400 Compliant ECC DIMM
- Supports 256MB, 512MB, 1GB, 2GB DIMM
- Supports standard SEC-DED with 72-bit ECC DIMM or supports Intel x4 Single Device Data Correction (x4 SDDC)

Expansion Slots
- One 64-bit 133MHz PCI-X slot (3.3V)
- Supports up to three devices through riser card

Networking Security (optional)
- Cavium CN-1120-X Security Macro Processor add-on card supports IPsec/SSL

System Management
- Total three 3-pin fan headers with control and tachometer monitoring
- Monitors voltage for CPU, Mem. & Power Supply
- Monitoring temperature for CPU & environment
- Pin header for Fault LED, Power LED & HDD activity LED
- One pin header for Chassis Intrusion detection
- Supports Serial Console Redirect
- Private memory chip for security information
- Supports Watch Dog Timer

Integrated LAN Controllers
- (4) Intel 82571 dual port Gigabit Controllers
- Configurable with total 8 Gigabit LAN ports, Max. 4 of 8 ports could be over Fiber connectors (opt.)

Integrated Graphics
- Onboard ATIi RN50 PCI graphics controller with 8MB memory

Integrated I/O
- (1) 40-pin IDE connector
- (1) 50-pin Compact Flash Type II connector
- (2) SATA connectors
- (1) pin header for USB ports (supports two USB 2.0 devices)
- (1) Shrouded header for serial port
- (1) Shrouded header for parallel port
- (1) pin header for PS/2 mouse and keyboard
- (1) pin header for VGA port
- (1) pin header for SMBUS connection
- (1) pin header for Switch/ LED connection
- (1) pin header for Fiber LAN LED display

Back Panel I/O Ports
- (1) serial port w/ D-Sub connector
- (2) USB 2.0 ports w/ dual-stack USB connector
- (8) RJ45 connectors with Transformer and LED
- (4) LAN ports could be configured to Optical SPF connectors (refer to available SKUs)

- AWARD BIOS on 4Mbit Flash ROM
- Supports ACPI 2.0
- Supports boot from USB device
- Power-on mode control for AC power loss recovery

Power Supply
- EPS 12V Power Supply (24-pin, 8-pin power connectors), support PSMI

Form Factor
- EEB 3.51 form factor (12" x 13"; 305x330mm)