Olympus Sonic WorkStation In-line Inspection System

Olympus Updated: 2007-09-11
Olympus Sonic WorkStation In-line Inspection System

The WorkStation base unit & control panel, coupled with the Sonic module appropriate to your application, is a semi-portable ultrasonic flaw detector that offers a wide variety of application solutions. Whether you require a general purpose flaw detector or a specific type of pulser/receiver, Olympus NDT can deliver. The unique open/close trunk design enables the customer to interchange front-end pulser/receivers. No longer will you be forced to compromise your testing requirements due to technology obsolescence or new applications.

The Sonic WorkStation is battery or AC operated and includes a full range of analog and digital outputs (at Rep Rate). It has the ability to adapt from one NDT discipline to the next in less than ten seconds with its innovative general purpose or customer/application specific modules and keypads. It boasts a 8 inch (203 mm) diagonal full VGA 640 x 480 pixel count color liquid crystal display.


* 300 kHz to 25 MHz bandwidth
* Square Wave Pulser
* 50 Hz - 10 kHz adjustable Pulser Repetition Frequency (PRF)
* Pulser Voltage: 30 - 300 volts, depending on configuration
* 110 dB gain, user defined steps
* Back Echo Attenuator (Sonic 210, 211)
* Multiple gates including IF/Surface following
* 4 digit precision thickness: 0.0040" to 300.0" (0.1016 mm to 7.62 m)
* Auto thickness calibration: E-E or IP-1st
* Multi-segment DAC (Sonic 210 , 211)
* CRT-like signal response
* Data Logger (Sonic 210, 211)
* Reference Memory (Sonic 210, 211)
* A-scan and setup storage
* PowerLink Technology - automatic transducer recognition and instrument set-up